Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
STARSAT 2020HD HYPER SIGNAL PROBLE
#1
Sir !
I have Starsat 2020hd hyper,
i buy it from Tunisia.
it now sow "signal weak",
also i do  'factory reset',
but no signal comes.
          Also i am "Mobile Hardware & software" technician. so which part of Box to change.I do ripar myself. so give me solution. please !!!
Reply
#2
Dear first try without diseqc switch. and check strong TP if you found same weak signal then you should check the output voltage of H and V on Tuner or LNB in port
Reply
#3
(02-05-2020, 02:01 PM)Azhar Kazmi Wrote: Dear first try without diseqc switch. and check strong TP if you found same weak signal then you should check the output voltage of H and V on Tuner or LNB in port

Sir mene diseqc swich nahi lagaya he, only one satellitedd direct+ dekhta hoo. other box working fine as same time. 
 Muje box me koi masla lagta he.
Reply
#4
g bilkul tuner section me fault hoga
Reply
#5
SIR ISKA TUNNER SECTION KASE SET HOGA KINDLY THORA SA GUIDE KR DAIN
Reply
#6
check kar k he pata chal sakta hy. koi ic kharab ho sakta hy ya diode ya transistor
Reply
#7
(03-03-2020, 07:23 PM)Azhar Kazmi Wrote: check kar k he pata chal sakta hy. koi ic kharab ho sakta hy ya diode ya transistor
Bhai ! Yeh picture mere sr2000HD HYPER pcb ki hai.
Red mark he waha pe 12.26 voltage
Yalow mark pe 1.7 voltage. Milta he.

To me kya karu to thik hoga ?



Attached Files Thumbnail(s)
   
Reply
#8
(04-01-2020, 02:16 PM)Hitesh Mori Wrote:
(03-03-2020, 07:23 PM)Azhar Kazmi Wrote: check kar k he pata chal sakta hy. koi ic kharab ho sakta hy ya diode ya transistor
Bhai ! Yeh picture mere sr2000HD HYPER pcb ki hai.
Red mark he waha pe 12.26 voltage
Yalow mark pe 1.7 voltage. Milta he.

To me kya karu to thik hoga ?

Dear jahan 1.7 hen wohan 12v hone chahyen. so coil k sath wala 6 pin regulator kharab ho sakta hy
Reply
#9
Kazmi bro ! I checking again. i  upload Screenshot.

Sir! Iam from india.i buy SR2000HD Hyper
3/4 year ago From Tunisia.
Now no signal problem.LNB PORT Voltage 2.6
I checked Horizontal & Vortical but sow 2.6V.
What can I do ? I have no schematic diagram also.
So please halp me. upload diagrams
Thank-you !


Attached Files Thumbnail(s)
               
Reply
#10
Dear

6 pin regulator is faulty near coil. remote it and if you found this then replace it otherwise direct given 12v to tuner only sinlge polarity will work
Reply


Forum Jump:


Users browsing this thread: 3 Guest(s)