Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Rs 232 port
#1
Sir, I have a problem in inserting the Rs 232 port in MM3_SU1506G_DSZ_V1.1 board. RS 232 port has 4 holes.
Reply
#2
dear four points for:

TX
RX
GND
VCC

Don't use vcc
Reply
#3
Sir, I have got that Rs 232 port from a normal Setellite receive. But it cant plug in MM3_SU1506G receiver board.

My receiver became dead after wrong flashing and now it is not recovered through USB. It only showing red light. I tried to flash it through Rs 232 port but port not inserting in its MM3_SU1506G board.
Reply
#4
use wires instead of rs232 connector and share the board picture also
Reply
#5
It has board of 1506g receiver and it has no Rs 232


Attached Files Thumbnail(s)
   
Reply
#6
HDMI aur AV port k darmian jo jack hy woh rs232 k liey hoga
Reply
#7
Sir, I have tried in that. It has 3 pins and the Rs 232 port plug has 4 holes and that's why rs 232 plug not inserted into that port on board.
Reply
#8
you have the old rs232 connector new has three wires only
Reply
#9
Sir, Rs 232 has 3 wires going in plug but plug hasĀ 4 holes...
Reply
#10
watch some video on youtube and get idea
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)