Kazmi Elecom Forum
Starsat 2000HD hyper problem - Printable Version

+- Kazmi Elecom Forum ()
+-- Forum: Board Index (/forumdisplay.php?fid=1)
+--- Forum: Digital Receiver/Set-Top Box (/forumdisplay.php?fid=20)
+--- Thread: Starsat 2000HD hyper problem (/showthread.php?tid=52)

Pages: 1 2


Starsat 2000HD hyper problem - sabz - 09-27-2019

Hi

I am noob in electronic repaire .
My reciver starsat hd 2000hd hyper in not boot . in front panel nothing shown . only blue lamp lights.

I use programmer an flash memory with new dump and nothing happend andthe problem not solved .

I search in web and find kazmi voltage test point and this is my reciver board test point .
I write my voltage in red color.

any one have any idea ?

thank a lot


RE: Starsat 2000HD hyper problem - aplkdu - 09-27-2019

Check power supply first


RE: Starsat 2000HD hyper problem - sabz - 09-28-2019

power supliy dead .

I use 12v 2A instead of its own power suplly .

maybe this borad need more than 2 ampers ?

thanks


RE: Starsat 2000HD hyper problem - aplkdu - 09-28-2019

i think 2 amp is enough.

Now check voltage on all coils mounted with regulators


RE: Starsat 2000HD hyper problem - sabz - 09-28-2019

the attached (in first post)picture is my coil voltage and i write my voltage in red color


RE: Starsat 2000HD hyper problem - aplkdu - 09-28-2019

i already seen it, check all voltage left to right according to board picture attached


RE: Starsat 2000HD hyper problem - sabz - 09-28-2019

complete voltage test point .


RE: Starsat 2000HD hyper problem - Azhar Kazmi - 09-28-2019

Dear!!

1.5v regulator 5 pin is faulty and 1.1v regulator 5/6 pin is also faulty. 12 v regulator for tuner H/V 6 pin is also faulty

first, replace the 1.5 regulator and 1.1 regulator ic. system will ON

then replace 12v regulator.

you can use buck converter supply modules if you don't have the regulator


RE: Starsat 2000HD hyper problem - sabz - 10-01-2019

I cant find these regulator .
1.5V is 5 pin and writed "LD4PH" on its back

12V is 6 pin and writed "GEC" on its back
1.1V is 6 pin and unreaable it back.

i cant find these data sheet to find where its out pins to use power supply out port on them.

what type of generic regulator can i use instead of them .


RE: Starsat 2000HD hyper problem - aplkdu - 10-02-2019

use buck converter module. search google