Kazmi Elecom Forum
Starsat Hyper 2000 reboot issue after software with ch321a - Printable Version

+- Kazmi Elecom Forum ()
+-- Forum: Board Index (/forumdisplay.php?fid=1)
+--- Forum: Programmer & Loader Tools (/forumdisplay.php?fid=8)
+--- Thread: Starsat Hyper 2000 reboot issue after software with ch321a (/showthread.php?tid=10776)



Starsat Hyper 2000 reboot issue after software with ch321a - babubhaiya - 07-30-2021

Salam brother

I have Starsat hyper 2000 receiver, I am facing reboot issue. 
Receiver start with boot when it reaches ON condition it reboot again.
i have tried by changing flash IC and uploaded different software.
but problem is still same.
Kindly help.


RE: Starsat Hyper 2000 reboot issue after software with ch321a - Azhar Kazmi - 07-30-2021

w.salam

dear change power supply and check


RE: Starsat Hyper 2000 reboot issue after software with ch321a - babubhaiya - 08-01-2021

kazmi sahab i have changed power supply. it didnt work.
please any other tip.

before replacing flash ic it was not uploading software from bootloader.
now it is updating software from bootloader, in some software it hangs and in some it keeps restarting.


RE: Starsat Hyper 2000 reboot issue after software with ch321a - babubhaiya - 08-01-2021

Dear I have also checked voltages as per your video all voltages at every stage are ok.


RE: Starsat Hyper 2000 reboot issue after software with ch321a - Azhar Kazmi - 08-04-2021

Then it is hard to troubleshoot. it may be dusty or dry. also try to cut 12v supply to LNB section and check